Not logged inAmerican Welding Society Forum
Forum AWS Website Help Search Login
Up Topic American Welding Society Services / Technical Standards & Publications / Pre qualified fillet question
- - By mallard Date 01-19-2007 22:03
In D1.1 is there a pre qualified procedure for a fillet weld?  Not a lap joint, not a corner or and edge joint just a straight fillet with one verticle member and one horizontal.  Such as would be used welding stiffeners in beams and base plates on tube columns?  Any help would be appreciated, thanks in advance.
Parent - By 803056 (*****) Date 01-20-2007 03:26
Yes.

Al
Parent - By pax23 (**) Date 01-22-2007 14:55
See Section 3.9 in the code. Those are your limitations/requirements. So long as you meet those you are OK. Of course, you must meet all other relevant requirements in Section 3, that should go without saying.
Up Topic American Welding Society Services / Technical Standards & Publications / Pre qualified fillet question

Powered by mwForum 2.29.2 © 1999-2013 Markus Wichitill