Howdy folks,
Maybe I should be throwing this one out in the shop talk group rather than here, but I really need some help! I bought an old Heath 442 cutting table a couple years ago and finally have found the time to give it some much needed attention. It`s an 81 model and has been doing a fairly respectable job for it`s age, and I know with some TLC, it`ll be running long past many of the newer machines. But today, when I was halfway through the electronic calibration steps, I found a voltage reading that just didn`t seem right. Are there any 'old school' Heath/ESAB / Stewart Warner tech guys around that I could get in touch with? Thanks for the terrific service you all provide!
                                                        Dave......the fool with the tools.