Not logged in
American Welding Society Forum
Forum
AWS Website
Help
Search
Login
Topic
Welding Industry
/
Technical Discussions
/ automated saddle welding
By
Tim Buyle
Date
09-11-2002 09:27
Anybody have ever seen an automated welding system for a special type of saddle welds : eg. a manhole in a pressure vessel that is NOT set up by an angle of 90° !!! : eg. angles of 30-60°
I am thinking about submerged arc.
By
GRoberts
Date
09-11-2002 16:24
I'm not sure if they have all the capabilities you are looking for or not, but check them out if you haven't yet.
http://www.cypressweld.com/cw-7.htm
By
Tim Buyle
Date
09-16-2002 06:46
I've checked this one earlier. No result.
Topic
Welding Industry
/
Technical Discussions
/ automated saddle welding
Forum
AWS.org
- Forum News & Help
American Welding Society Services
- Certifications
- Technical Standards & Publications
- Conferences & Shows
- AWS Learning & Education
Welding Industry
- General Welding Discussion
- Technical Discussions
- Inspection & Qualification
- Welding Fundamentals
- Processes
- ASME Codes
- Welding Safety
- Metallurgy
- Welding Documents & Downloads
Welders and Inspectors
- Education & Training
- Welding Equipment Classifieds
Sections
- Section 7: San Francisco
- Section 32: Rochester
- Section 39: Colorado
- Section 41: Puget Sound Olympic
- Section 55: Arizona
- Section 81: Nebraska
- Section 110: North Florida
- Section 112: Florida West Coast
- Section 135: Nevada
- Section 156: Inland Empire
Chit-Chat & Non-Welding Discussion
- Off-Topic Bar and Grill
Powered by
mwForum
2.29.2 © 1999-2013 Markus Wichitill