IN TOO MANY WELD TRAINING ESTABLISMENTS WELDERS GRADUATE FROM THE MIG COURSE
GO FOR A JOB THEN PLAY AROUND WITH THE WELD CONTROLS.

A survey of 10 weld educators revealed that not one of them new where the spray start point was for
an 0.045 wire, 85/15 CO2 gas on the digital wire feed control. For too many years eductors have
focussed on weld skills rather than process expertise, this is a fundametal cause of why we have so
many weld shop issues, why weld shops rely on salesmen for advice and why few robots are optimized.For a fresh practical solution check out www.weldreality.com