Not logged in
American Welding Society Forum
Forum
AWS Website
Help
Search
Login
Topic
Welding Industry
/
Inspection & Qualification
/ Acceptance criteria for distorted spool
By
Richman
Date
07-23-2008 11:10
[deleted]
By
Jim Hughes
Date
07-23-2008 12:09
Richman,
Look at the PFI (Pipe Fabrication Institute) they have some guidelines. Also, if it is ASME then B31.1 gives you some guidence.
Thanks
Jim
By
jon20013
Date
07-23-2008 12:25
Good answer, Jim. I was going to say this is "normally" project spec stuff but both sources you mention are good guidance.
By
js55
Date
07-23-2008 19:53
PFI ES-3 to be specific.
Topic
Welding Industry
/
Inspection & Qualification
/ Acceptance criteria for distorted spool
Forum
AWS.org
- Forum News & Help
American Welding Society Services
- Certifications
- Conferences & Shows
- Technical Standards & Publications
- AWS Learning & Education
Welding Industry
- General Welding Discussion
- Technical Discussions
- Inspection & Qualification
- Processes
- Welding Fundamentals
- ASME Codes
- Welding Safety
- Metallurgy
- Welding Documents & Downloads
Welders and Inspectors
- Education & Training
- Welding Equipment Classifieds
Sections
- Section 7: San Francisco
- Section 32: Rochester
- Section 39: Colorado
- Section 41: Puget Sound Olympic
- Section 55: Arizona
- Section 81: Nebraska
- Section 110: North Florida
- Section 112: Florida West Coast
- Section 135: Nevada
- Section 156: Inland Empire
Chit-Chat & Non-Welding Discussion
- Off-Topic Bar and Grill
Powered by
mwForum
2.29.2 © 1999-2013 Markus Wichitill