Not logged in
American Welding Society Forum
Forum
AWS Website
Help
Search
Login
Topic
Welding Industry
/
Technical Discussions
/ Groove weld depth to width limitations
By
bmaas1
Date
04-12-2003 02:10
In D1.1 where might I find information on this.
Thanks,
Brian Maas
By
DGXL
Date
04-12-2003 02:17
D1.1:2000, 3.7.2 and Figure 3.1.
By
bmaas1
Date
04-12-2003 02:19
Thank you,
Now is that just for prequalified or just in general?
Thanks,
Brian Maas
By
DGXL
Date
04-12-2003 02:51
If a weld exceeds these depth/width limitations, then qualification is required.
By
bmaas1
Date
04-12-2003 03:36
Thank you,
Brian Maas
Topic
Welding Industry
/
Technical Discussions
/ Groove weld depth to width limitations
Forum
AWS.org
- Forum News & Help
American Welding Society Services
- Certifications
- Conferences & Shows
- Technical Standards & Publications
- AWS Learning & Education
Welding Industry
- General Welding Discussion
- Technical Discussions
- Inspection & Qualification
- Processes
- Welding Fundamentals
- ASME Codes
- Welding Safety
- Metallurgy
- Welding Documents & Downloads
Welders and Inspectors
- Education & Training
- Welding Equipment Classifieds
Sections
- Section 7: San Francisco
- Section 32: Rochester
- Section 39: Colorado
- Section 41: Puget Sound Olympic
- Section 55: Arizona
- Section 81: Nebraska
- Section 110: North Florida
- Section 112: Florida West Coast
- Section 135: Nevada
- Section 156: Inland Empire
Chit-Chat & Non-Welding Discussion
- Off-Topic Bar and Grill
Powered by
mwForum
2.29.2 © 1999-2013 Markus Wichitill