Hello All, I have posted a number of basic aides that can assist folks when they are trying to fit and hold various items to be fabricated. For most of you a turnbuckle is probably one of the first items that you found a host of uses for. I am mainly including this for those who might be somewhat new to the trades and are looking for low-budget items to make life easier. This particular turnbuckle has a couple of angle brackets bolted to it's ends, you could either tack-weld or clamp them to various items to move or hold them in place for you while performing additional fit-up tasks, squaring, or final weld-out. They could be attached to plates to be tacked onto parts, attached to chains, nylon slings, wire rope slings, and numerous other items for pulling and pushing purposes. I have included a few photos to give some ideas. Anyone with other suggestions or variations, I would greatly appreciate the additional input. Best regards, Allan