Not logged inAmerican Welding Society Forum
Forum AWS Website Help Search Login
Up Topic Welding Industry / Metallurgy / weld procedure for Four wheel drive input shaft
- By firstpass (**) Date 11-16-2017 04:10
bearing surface of input shaft has been grooved by excessive use and little maintenance.  The shaft is splined on one end and has a yoke on the other.  The bearing surface is about two inches long.  Question???  Does this type of steel used in this particular application need to be annealed before welding.  If so after welding does it need to be quenched in an oil bath after being brought up to temperature.

Firstpass
Up Topic Welding Industry / Metallurgy / weld procedure for Four wheel drive input shaft

Powered by mwForum 2.29.2 © 1999-2013 Markus Wichitill