For a company, but you figure once you throw in a set of wrenches up to 1-1/4", set of metric up to 30 mm, then the same for sockets 1-1/4" and 30 mm ,2 - 12" pipe wrenches, 2 - 18" pipe wrenches, 2 - 24" pipe wrenches, couple two foot squares, 3lb sledge, 16 oz ball peen, vise grips, c clamps, tin snips, pliers, 50' tape, 30' tape, 16 meter tape, 8 meter tape, 12" crescent, 15" crescent, 15" and 18" alignment bars, and I don't know there is probably little over half a dozen other items on the list. You could probably fit it into the rat boxes the millwrights use but you'd be seriously squeezing it and then where would you put your hood, leathers, rod holder, tig cups, stinger, etc that you are required to have from the welders tool list?